7
HANDLING
PROTECT C is designed and constructed so that all necessary steps for
start-up and operation can be performed without any internal
manipulation of the unit. Maintenance and repair work may only be
performed by trained and qualified personnel.
Illustrations are provided to clarify and facilitate certain steps.
If danger to personnel and the unit cannot be ruled out in the case of
certain work, it is highlighted accordingly by pictograms explained in
chapter 3.
HOTLINE
If you still have questions after having read these operating instructions,
please contact your dealer or our “Hotline”:
Tel: +49 2902 763100
Internet:
www.aegps.com
COPYRIGHT
No part of these operating instructions may be transmitted, reproduced
and/or copied by any electronic or mechanical means without the
express prior written permission of AEG.
© Copyright AEG 2014. All rights reserved.
To Next Page
Loading...
