What to do if AEG UPS shows Heat sink Over Temperature alarm?
If the AEG UPS displays a Heat sink Over Temperature alarm, ensure that the fans are functioning correctly and that the air intake vents on the uninterruptible power supply are not blocked. The cause may be fan failure. After the maximum temperature is reached, the uninterruptible power supply shuts down.
What to do if AEG protect d. 3000 reports Fan Failure?
If the AEG UPS reports a Fan Failure, contact your service representative immediately and remove the load.
What to do if my AEG protect d. 3000 shows Charger Failure alarm?
If your AEG UPS shows a Charger Failure alarm, contact your service representative.
What to do if AEG protect d. 3000 UPS signals Battery DC Over Voltage?
If the AEG UPS signals a Battery DC Over Voltage, contact your service representative.
How to fix Battery Disconnected alarm on AEG UPS?
To address a Battery Disconnected alarm on your AEG UPS, ensure that all batteries are correctly connected. If the condition persists, contact your service representative.
Key specifications, performance metrics, and operational parameters.
Crucial safety precautions applicable to the UPS and accessories.
Detailed safety guidelines tailored for the PROTECT D series.
Details of ports, connectors, and interfaces on the rear panel.
Instructions for connecting internal and external battery units.
Steps to connect devices requiring UPS power protection.
Steps to power on, initialize, and configure the UPS for first use.
Procedure for using the immediate UPS shutdown feature.
Guidance on identifying and resolving UPS issues and interpreting alarms.
Safety precautions and steps for replacing UPS batteries.
General| Output power capacity | 3000 VA / 2700 W |
|---|---|
| Nominal output voltage | 230 V |
| Nominal input voltage | 230 V |
| Topology | Line-interactive |
| Waveform type | Sine wave |
| Communication ports | USB, RS-232 |
| Form factor | Tower |
| Output Voltage | 230 V ± 5% |
| Typical Backup Time at Full Load | 5 minutes |
| Operating Temperature | 0 - 40 °C |
| Storage Temperature | -15-45°C |
| Relative Humidity | 0 - 95% non-condensing |
| Product type | Line interactive |
| Battery type | Sealed Lead Acid |
| Frequency Range | 50/60 Hz |
| Safety Certifications | CE, EN 62040-1-1, EN 62040-2 |
| Input Voltage Range | 160 - 290 V |
| Typical Backup Time at Half Load | 15 minutes |
To Next Page