AEG TR9T75680 - Drum Light on; Possible Causes of Unsatisfactory Drying Results

If you do not turn off the appliance, the anti-crease phase starts
(not active with all programmes). Flashing symbol signals the
execution of the anti-crease phase. Laundry can be removed
during this phase.
To remove the laundry:
1. Push the Ein/Aus button for 2 seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying results:
• Inadequate default dryness level settings. See chapter
Adjustment of default dryness level
• Room temperature is too low or too high. Optimal room
temperature is between 18°-25°C.
8.12 Drum light on
3s
3s
3s
Touch and hold down Leise button by around 3 seconds.
The light inside the drum is on.
8.13 Possible causes of unsatisfactory drying results:
• The filter is clogged. Clogged filter makes drying inefficient.
• The airflow slots are clogged.
• The drum is dirty.
• Inadequate default dryness level settings. See chapter
Adjustment of default dryness level
• Room temperature is too low or too high. Optimal room
temperature is between 18°-25°C.
37/64
DAILY USE