If the condensed water container is full, the programme stops
automatically. The
Behälter
symbol comes on the display and
you must empty the water container.
To empty the water container:
1. Pull the water container out keeping it in a horizontal position.
2. Pull the plastic connection out and drain the water into a basin or
equivalent receptacle.
3. Push the plastic connection back in and place the water
container back into position.
4. To continue the programme press the Start/Pause button.
10.3 Cleaning the condenser
If the symbol
Kondensator
flashes on the display, inspect the
condenser and its compartment. If it is dirty, clean it. Do the check
not less than once a 6 months.
WARNING!
Do not touch the metal surface with bare hands. Risk of injury.
Wear protective gloves. Clean carefully to avoid damaging the
metal surface.
To inspect:
42/64
CARE AND CLEANING
To Next Page
