Error
code
Possible cause Remedy
EH0
The mains supply is un‐
stable.
When the appliance is
showing EH0, please
wait until main supply is
stable than press start. If
the appliance pause the
cycle without any indica‐
tion then press the cycle
start. If the warning will
occur check the power
cord / socket integrity or
main supply.
If the display shows other error codes, deactivate and activate the
appliance. If the problem continues, contact the Authorised Service
Centre.
In case of different problem with the tumble dryer check the table
below for possible solutions.
47/64
TROUBLESHOOTING
To Next Page
Loading...
