AEMC 1000N - Warning; International Electrical Symbols

Megohmmeter Model 1000N/1100N
- 4
-
:DUQLQJ
These safety warnings are provided to ensure the safety of
personnel and proper operation of the instrument.
WARNING: HIGH VOLTAGE PRESENT
• Do not attempt to perform any tests with these instruments
until you have read the instruction manual.
• Safety is the responsibility of the operator!
• Tests are to be carried out only on non-energized circuits!
Check for live circuits before making resistance
measurements (safety check).
• The Megohmmeters Models 1000N and 1100N are sources
of high voltage, as is the sample connected to them. All
persons performing or assisting in the tests must employ all
safety precautions to prevent electrical shock to themselves
and to others.
•
AE
MC
®
considers the use of rubber gloves to be an excellent
safety practice even if the equipment is properly operated and
correctly grounded.
• When testing capacitance samples, make sure that they have
been properly discharged and that they are safe to touch.
Dielectric insulation samples should be short-circuited for at
least five times the amount of time they were energized.
• Megohmmeters should never be used in an explosive
environment.
• Use the leads supplied with the megohmmeters. If they are
defective or worn, replace before testing.
,QWHUQDWLRQDO(OHFWULFDO6\PEROV
This symbol signifies that the instrument is protected by double
or reinforced insulation. Use only specified replacement parts
when servicing the instrument.
This symbol signifies CAUTION! and requests that the user refer
to the user manual before using the instrument.
Risk of electric shock. The voltage at the parts marked with this
symbol may be dangerous.