Installation and Operation Manual for electric kettle
Document version: 1.0.1, aeno.com
ASBISc Enterprises PLC. All rights reserved
10. Do not place anything on top of the power cord or allow it to come into
contact with sharp edges or hot surfaces.
11. Make sure that the power cord does not hang over the edges of furniture or
touch surfaces that could damage the insulation.
12. Do not wrap the power cord around the device.
13. If the power cord is damaged, first power off the outlet, then unplug the
device. The power cord should only be replaced by a service technician.
14. Do not leave the switched on device unattended.
15. Do not turn on the electric kettle without water or with an insufficient
amount of water (below the "MIN" mark on the inside of the body). In this
case the device will switch off before the water boils.
16. Do not pour water above the "MAX" mark on the inside of the body.
17. Do not turn on the kettle with the lid open.
18. Do not move the device while it is operating.
19. Do not open the kettle while the water is heating or during the first few
minutes after boiling.
20. Make sure that the lid is tightly closed before lifting the device. Do not touch
the hot body of the device with your hands, lift the device from the stand by
the handle only.
21. Be careful when pouring hot water, do not tilt the kettle with water too
sharply.
22. Use the device only with the supplied stand.
23. Do not immerse the kettle, the stand with electrical contacts, the power
cord or the power cord plug in water or other liquids. Do not allow
condensation to form on them.
24. If the device has fallen into water, do not touch it under any circumstances
and disconnect it from the power supply immediately.
25. Never use the device or stand that has been immersed in water. Have them
checked by an authorized service centre.
26. If you notice malfunction or damage, stop using the device immediately and
contact a service centre.
27. The device should only be repaired by a qualified service technician. Never
try to repair the device yourself.
28. Do not make any modifications to the device or accessories. Useit only with
original and manufacturer-recommended accessories, consumables and/or
replacement parts.
29. Disconnect the device from the power supply when you finish using it and
before cleaning it.
To Next Page
Loading...
