Installation and Operation Manual for electric kettle
Document version: 1.0.1, aeno.com
ASBISc Enterprises PLC. All rights reserved
WARNING! Use only the supplied stand to connect the device to the power
supply. Use of other stands may result in damage to the device.
2.2 Boiling water
In order to boil water in the electric kettle, the next steps must be followed in
sequence:
1. Remove the kettle from the stand.
2. Press the button on the handle of the device and open the lid.
3. Draw just the right amount of water.
4. Close the lid tightly.
5. Place the kettle on the stand.
6. Insert the plug of the power cord into the power outlet
7. Lower the switch. The indicator will light up and the water heating process
will start.
8. After the water boils, make sure that the switch automatically returns to its
previous position and the light goes out.
NOTE. To interrupt the heating or boiling process, raise the switch or remove
the kettle from the stand. The indicator light will turn off.
9. Remove the kettle from the stand and carefully pour water from it.
WARNING! When pouring hot water from the kettle, the lid must be closed.
Do not tilt the device harshly.
NOTE. Allow the device to cool down for at least 30 seconds before boiling
water again.
10. Be sure to remove the power cord plug from the power outlet when you are
finished using the device.
The whole process of filling the kettle and boiling water is shown in Figure 7.
To Next Page
Loading...
