AENO EK2 - Figure 6 - Water Level Marks

Installation and Operation Manual for electric kettle
AENO
EK2
©
ASBISc Enterprises PLC. All rights reserved
Document version: 1.0.1, aeno.com
Page
19
of
34
NOTE. Before connecting the device to the power supply for the first time,
make sure that the rated voltage indicated in the technical documentation
corresponds to the electrical voltage in the outlet.
 Fill the kettle with water up to the "MAX" mark. Boil (see section 2.2) and
drain the water.
NOTE. Water level marks are located on the inner surface of the device.
Figure 6 – Water level marks
Do not pour water into the kettle below the "MIN" mark and above the "MAX"
mark.
 Repeat the procedure.
 Allow the device to cool down.
 Wipe the exterior and interior of the device with a dry cloth. Make sure there
is no moisture left on the stand and the kettle.