Installation and Operation Manual for electric kettle
ASBISc Enterprises PLC. All rights reserved
Document version: 1.0.1, aeno.com
№ Problem Possible causes Solution
3 There is power
supply in the mains,
as well as water in
the kettle, but the
device does not
turn on
The device has not
cooled down after the
overheat protection has
tripped
Allow the device to cool
down before turning it
on again
Short-circuit in the
electrical circuit of the
device
Contact the service
centre
4 The device does not
turn off
automatically after
boiling water
The device lid is not
closed
Make sure the device lid
is tightly closed
The switch is defective Contact the service
centre
WARNING! If none of the possible solutions solves the problem, contact your
supplier or service centre. Please do not disassemble or attempt to repair the
device on your own.
To Next Page
Loading...
