VI. LOW BATTERY ALARM FUNCTION
NanoMote Quad will send battery report to the lifeline group when button is triggered during
the sleep mode. If the battery level of the NanoMote Quad is less than 20%, the NanoMote
Quad will send a low battery alarm to the main controller.
VII. WAKE UP
Pressing and holding button for 5 seconds and then release so the NanoMote Quad will wake up
itself and send wake-up notification out to Z-Wave Controller. After that, it can be operated to
update parameters, OTA, and detect battery level etc.
VIII. CHILD LOCK FUNCTION
Child Lock function. If enable the Child Lock function, the LED indicator will not be on when press
down the button. To switch on/off the Child Lock function, please press and hold the button for 10
seconds, the LED indicator will be solid on in red. Then release the button, the LED indicator will
be continuously stay in red for 2 seconds. During this 2 seconds, please click the button once, the
LED light will be blink fast in red for 2 seconds.
IX. TESTING Z-WAVE NETWORK RANGE
Press and hold the button for 15 seconds, the LED light will be solid on in purple. Then release the
button, the LED light will be stay in purple for 2 seconds, during this 2 seconds, please click the
button once, it will start to test the Z-Wave network range and LED light will blink fast in purple.
After finish the test, if the LED light is in green, it refers to strong signal; if in blue, it refers to
medium signal, and if in red, it refers to weak signal or no signal.
TIP:
This function works only when NanoMote Quad has been included into a Z-
Wave network.
To Next Page
Loading...
Need help?
General
