AEOTEC Engineering Specification
Page 13
4 3 2
Enable Hour:
Valid value are 0-23 and 127. Value 127 means use last valid setting.
Enable Minute:
Valid value are 0-59 and 255. Value 255 means use last valid setting.
Disable Hour:
Valid value are 0-23 and 255. Value 255 means use last valid setting.
Disable Minute:
Valid value are 0-59 and 255. Value 255 means use last valid setting.
Example:
If you want to set Night Light Mode to be enable at 19:00 at night and disable at
07:30 in the morning, you just need to configure:
Value1=0x13, Value2=0x00, Value3=0x07, Value4=0x1E.
0x5B(91)
Threshold Power (W) for inducing automatic report.
Value Description
0 Disable
1..2300 1-2300W
0x5C(92)
Threshold Power Consumption (kWh) for inducing automatic report.
Value Description
0 Disable
1..10000 1-10000kWh
Threshold Current (A) for inducing automatic report.
Value Description
0 Disable
1..100 0.1-10A. Unit is 0.1A.
Configure which meter reading will be periodically report via Lifeline.
7 6 5 4 3 2 1 0
Reserved
Reserved
Reserved
Reserved Current Voltage Power Power
Consumption
The format of the parameter is Bit field (Checkboxes). The parameter MUST be
treated as a bit field where each individual bit can be set or reset. A graphical
configuration tool SHOULD present this parameter as a series of checkboxes.
Note:
The sending frequency is related to Configuration Parameter 0x6F (111).
Configure the sending frequency of Meter Report.
Value Description
0 Disable
600..2592000 600-2592000s. (10minute-30day)
Factory Reset or Initialization (Write Only)
Value Description
1431655765
(0x55555555)
Factory Reset:
Restore the product to factory settings and remove from the
network.
Other Initialization:
Initialize all configuration parameters to default values.
To Previous Page
Loading...
Need help?
General
