Aeotec Water Sensor 7 Pro - Association Group 2 Commands (Parameter 6); BASIC Command Values (Parameters 7-8); Command Frame Time Delays (Parameters 9-10); Tamper Alarm Delay (Parameter 11-12)

2
Switch after Water Leakage Stop
Parameter 6: Command Sent to Devices of Association Group 2
This parameter defines which commands is sent to 2nd Association Group
Size: 1 Byte, Default Value: 2
Setting
Description
0
On
1
Off
2
On and Off
Parameter 7: BASIC command value sent to 2nd Association Group on On event
This is the BASIC command value sent in case of On event.
Size: 1 Byte, Default Value: 255
Setting
Description
0 - 99
Value
255
Value
Parameter 8: BASIC command value sent to 2nd Association Group on Off event
This is the BASIC command value sent in case of Off event.
Size: 1 Byte, Default Value: 0
Setting
Description
0 - 99
Value
255
Value
Parameter 9: Time Delay of On command frame
On command is sent after a delay defined in this parameter.
Size: 2 Byte, Default Value: 0
Setting
Description
0 - 32400
seconds
Parameter 10: Time Delay of Off command frame
Off command is sent after a delay defined in this parameter.
Size: 2 Byte, Default Value: 0
Setting
Description
0 - 32400
seconds
Parameter 11: Delay of Tamper Alarm Cancellation
Time a tamper alarm is delayed.
Size: 2 Byte, Default Value: 0
Setting
Description
0 - 32400
seconds
Parameter 12: Reporting Tamper Alarm Cancellation