The remote control is pre-programmed
No pairing with the receiver required
STEP 6
Pairing the Remote Control
Controlling the Fan
1. Fan ON/OFF
2. Fan Speed UP/DOWN
2a. Fan Speed indicator 1-6
3. Forward / Reverse
3a. Use Forward mode (counterclockwise) for cooling
3b. Use Reverse mode (clockwise)
to circulate warm air
4. Light ON/OFF
4a. To DIM, press and HOLD light buon
to cycle from bright to dark.
(LIGHT SWITCH at DIMMING posion)
Pairing Mulple Fans per Remote Control
One remote control can control up to 8 fans (within a 7m (23”) radius).On ALL receivers verify that
the “Learn” switch is in the “O” posion. Switch on the mains power to acvate ALL receivers at the
same me, indicated by one ‘beep’. Within 60 seconds, press and hold the ON/OFF buon on the
remote control (min. 3 seconds) unl fan receiver issues three ‘beeps’.
!
1
4
3b
2
2a
3
3a
4a
LIGHT SWITCH
O LIGHT DIMMING
| LIGHT ON/OFF
Pairing a Single Fan per remote control: LEARN MODE
NOTE: Blades must be aached prior to tesng the fan
1. On Receiver: Verify that the “Learn” switch is in the “O” posion
2. Open baery cover & insert baeries.
3. Switch on the main power to acvate the receiver, indicated
by one beep. (Energise one fan reciever at a me).
4. Within 60 seconds aer the power is turned on (one beep),
press and hold the ON/OFF buon on the Remote Control
(min. 3 secs.) unl Fan Receiver issues three ‘beeps’ which
indicates successful pairing.
5. On Receiver: switch the “Learn” switch to “X” (this will
lock the pairing code with the remote)
6. Finish STEP 7, 8 & 9 and press ON/SPEED buon to test
fan funcons.
7. To re-pair, repeat steps 3 to 5
NOTE: Power must be off for 10 seconds min. before repairing.
The Remote Control and Fan Receiver will memorise the pairing
code for future use even if mains power is switched off.
LIGHT SWITCH: Select ON/OFF or DIMMING for the light funcon.
(Light will maintain last seng if turned off)
7