Note: If no LED lights up or is illuminated permanently, make sure the battery
is inserted the correct way and that a proper reset has been performed. Do not
install the batteries backwards. You can permanently damage the outdoor
sensor
Note: The LED can be hard to see in bright light.
Note: We recommend lithium batteries for cold weather climates, but
alkaline batteries are sufficient for most climates.
We do not recommend
rechargeable batteries. They have lower voltages, do not operate well at wide
temperature ranges and do not last as long, resulting in poorer reception.
RF (Radio Frequency) Receiving Mode
1. After power-on, the weather station enters RF receiving state for 144 seconds.
2. The Console receives the temperature, humidity, wind speed and rain data
every 48s, receiving light data every 60s. If there is no new signal received from
the sensor for eight consecutive periods, the outdoor temperature and humidity
will display “----”. The base station will then start searching for a new remote
sensor signal for 144s.
3. If the outdoor data has been lost or batteries have been changed in the transmitter,
press the reset button on the solar power device to re-send the signal and hold the
“▼” key for 4s to enter manual RF learning mode.
4
.
Do not press any key before outdoor sensor data received, otherwise the
outdoor sensor learning mode will be terminated. When the outdoor transmitter
has been registered, the base station will automatically switch to the normal
display mode from which all further settings can be performed by the user.
5. If there is no temperature reading in the indoor station, make sure the units are
within range of each other or repeat the battery installation procedure.
Note: Normally, radio communication between receiver and transmitter in the
open can reach up to 100 metres provided that there are no interfering obstacles
such as buildings, trees, vehicles, high voltage lines, etc.
Radio interference from PC screens, radios or TV sets can, in extreme cases, entirely
cut off radio communication. Please take this into consideration when choosing
standing or mounting locations.
To Next Page
Loading...
