To Next PageTo Next Page
Need help?Do you have a question about the AERMEC ANL070HA and is the answer not in the manual?
General| Cooling Capacity | 7.0 kW |
|---|---|
| Energy Efficiency Ratio (EER) | 3.2 |
| Coefficient of Performance (COP) | 3.6 |
| Refrigerant | R410A |
| Type | Air-to-Water Heat Pump |
| Power Supply | 50Hz |
Guidelines for safe installation, including reading instructions and minimizing risks.
Step-by-step procedure for charging the hydraulic system, including important precautions.
Procedure for draining the hydraulic system, including necessary steps and precautions.
Essential requirements for electrical connections, including circuit breakers and earthing.
Critical warnings and steps for first start-up, including safety checks and unit power.
Pre-power up checks: safety, fixing, clearances, power supply, connections.
Checks after powering up: voltages, connections, compressor heater operation.
Procedure for initiating the unit's first start-up.
Checks during unit operation: refrigerant circuit, superheat, discharge temperature.
Functionality and checks for the anti-freeze alarm system protecting the heat exchanger.
Operation of the water flow alarm to prevent compressor/pump damage due to insufficient flow.
Annual checks for the hydraulic circuit: filter, air vents, piping, anti-freeze.
Annual checks for the electric circuit: safeties, voltage, connections, crankcase heater.
