AERMEC ANL070 - User Manual

18.01. 6755441_03
INSTALLATION MANUAL
CHILLERS
REVERSIBLE HEAT PUMPS
CONDENSING UNITS
• EXTERNAL UNITS
• HIGH EFFICIENCY
• HOT WATER PRODUCTION UP TO 50 °C
Aermec
participates in the EUROVENT Programme: LCP.
The products of interest can be found on:
www.eurovent-certification.com
EN
ANL
ANL-H
020-202

AERMEC ANL070 Specifications

General

Brand	AERMEC
Model	ANL070
Category	Heat Pump
Language	English

Summary

GENERAL INSTRUCTIONS FOR THE INSTALLER

SAFETY INSTRUCTIONS AND INSTALLATION STANDARDS

Installation by qualified technician, adhere to safety rules and national standards.

ELECTRICAL CONNECTIONS

MANDATORY REQUIREMENTS

Essential requirements for electrical connections, including circuit breakers and earthing.

ELECTRICAL POWER SUPPLY CONNECTIONS

WARNINGS AND FIRST START-UP

Precautions before electrical connection and initial start-up procedures.

CHECKS AND FIRST START-UP

8.2. START-UP

8.2.1. PRELIMINARY CHECKS BEFORE POWERING UP

Checks before powering up the unit, including safety and fixation.

8.2.2. CHECKS TO BE DONE WHEN POWERED UP

Checks after powering up, including voltage and compressor heater operation.

8.3. FIRST START-UP

Steps for initiating the unit's first start-up after thorough checks.

8.3.1. CHECKS WITH THE UNIT RUNNING

Operational checks on refrigerant circuit, superheat, and discharge temperature.

SAFETY AND CONTROL DEVICES CHECKS

Verifying operation of safety devices like high pressure pressostat and anti-freeze.

PROCEDURE FOR SELECTION OF SYSTEM TYPE

13.1. HOW TO MODIFY A USER MENU PARAMETER

Guide to changing user-configurable parameters on the control board.

13.2. HOW TO MODIFY AN INSTALLER MENU PARAMETER

Guide to changing installer-specific parameters on the control board.