EasyManuals Logo

AERMEC FCA-R Series Directions For Use

AERMEC FCA-R Series
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
COOLING PROGRAM
1) PRESS THE MODE KEY (PROGRAMS)
Press the MODE key repeatedly until the symbol appears. The temperature is set to 26 °C.
The speed is set to AUTOMATIC.
2) PRESS THE “ON/OFF” KEY
The unit starts running and the “C” blue led lights up.
3) ADJUST THE TEMPERATURE
To adjust the temperature set, press the key to increase and the key to lowered:
– press the key to increase;
– press the key to lowered.
Each time either of these keys is pressed, the temperature is changed by 1 °C between 18 and
32 °C. The display shows the value set.
4) PRESS THE FAN KEY
Use the FAN key to select low , medium or high speed.
5
1
2
3
4
DEHUMIDIFICATION PROGRAM
1) PRESS THE MODE KEY (PROGRAMS)
Press the MODE key repeatedly until the symbol appears. The speed is set to AUTOMATIC
and cannot be modified. The temperature can be increased or lowered by 1 to 5 degrees in
relation to the value automatically set by the microprocessor.
2) PRESS THE “ON/OFF” KEY
The unit starts running and the “C” Blue led lights up.
DEHUMIDIFICATION OPERATION
When the unit is on dehumidification mode, operation of all components is controlled automa-
tically by the microprocessor.
When switched on, the fan coil runs a 3 minutes cooling cycle, after which it controls the ope-
ration of all components so as to keep the temperature constant and remove any humidity
from the air.
3
1
2
HEATING PROGRAM (HEATING PUMP)
1) PRESS THE MODE KEY (PROGRAMS)
Press the MODE key repeatedly until the symbol appears. The temperature is set to 23 °C.
The speed is set to AUTOMATIC.
2) PRESS THE “ON/OFF” KEY
The unit starts running and the “C” red led lights up.
3) ADJUST THE TEMPERATURE
To adjust the temperature set, press the key to increase and the key to lowered:
– press the key to increase;
– press the key to lowered.
Each time either of these keys is pressed, the temperature is changed by 1 °C between 18 and
32 °C. The display shows the value set.
4) PRESS THE FAN KEY
Use the FAN key to select low , medium or high speed.
5
1
2
3
4
GB

Other manuals for AERMEC FCA-R Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AERMEC FCA-R Series and is the answer not in the manual?

AERMEC FCA-R Series Specifications

General IconGeneral
BrandAERMEC
ModelFCA-R Series
CategoryFan
LanguageEnglish

Related product manuals