AERMEC NLC H - Start-up Procedure; Initial Operations (No Voltage to Live Unit); Commissioning and System Checks

EN - 15
NLC
NLC_HA/HE cod: 4037315_01

A er having powered up the unit the control board will
carry out preliminary opera ons before being ready
for use. This ini al procedure takes around 60 seconds
to complete. During the ini al loading procedure two
screens are displayed: a start-up screen and a screen to
select the system language. These screens are detailed
in the table below.
        

   

  
C

Wait please 6s
A
Installer
ENTER for change
Language:
Time show mask:
English
ESC to confirm
20
A
this value shows the remain-
ing time to starting the software loaded on the unit, and passing the
to system language selection

this parameter shows the current language set for
the system. To change the language follow the instructions shown on
the screen.
C
      this value shows the
remaining time to modify the language. When the time elapses the
display goes to the main screen (Main screen - General monitoring).
    


