EN - 5
NLC
NLC_HA/HE cod: 4037315_01
The NLC AERMEC units are constructed according to the recognised
technical standards and safety regulations. They have been designed for air
conditioning and domestic hot water production (DHW) and must be used
for this purpose in accordance with their technical features. The company
shall not be contractually or non-contractually liable for any damage to
people, animals or objects, for failures caused by errors during installation,
adjustment and maintenance or incorrect use. All the uses not expressly
indicated in this manual are not allowed.
Deliver the following instructions plus all the complementary documentation
to the system user, who shall be responsible for keeping the instructions so
that they are always available when needed.
Read carefully this chapter; all the procedures must be carried out by
qualified personnel according to the regulations in force in the various
countries.
The warranty of the device does not in any case cover costs incurred as a
result of motorised ladders, scaffolding or any other lifting systems made
necessary to carry out the operations under warranty.
Do not modify or tamper with the appliance as dangerous situations may
be created and the manufacturer will not be liable for any damage caused.
The warranty shall not be valid if the indications mentioned above are not
observed.
The appliance must be installed by an authorised and qualified technician,
in compliance with the national legislation in force in the country of
destination.
Aermec shall not be held responsible for any damage whatsoever resulting
from the non-compliance with these instructions.
Before starting any kind of work, it is necessary TO READ CAREFULLY THE
INSTRUCTIONS, AND TO PERFORM THE SAFETY CHECKS TO REDUCE ALL
HAZARDS TO A MINIMUM. All the personnel in charge must be aware of
the operations and the risks that may arise when all the unit installation
operations begin.
The warranty of the device does not cover costs incurred as a result of
ladders, scaffolding or any other lifting systems made necessary to carry out
operations under warranty.
Do not modify or tamper with the chiller as this may cause dangerous
situations and the manufacturer will not be liable for any damage caused.
The warranty shall not be valid if the indications mentioned above are not
observed.
The unit must be installed by an authorised and qualified technician, in
compliance with the national legislation in force in the country of destination
(MD 329/2004). AERMEC shall not be held responsible for any damage
whatsoever resulting from the non-compliance with these instructions.
Before starting any work, it is necessary TO READ CAREFULLY THE
INSTRUCTIONS, AND TO PERFORM THE SAFETY CHECKS TO AVOID ANY
RISKS.
All the personnel in charge must be aware of the operations and the risks
that may arise when all the unit installation operations begin.
The units can be identified using:
- that includes the product identification data
IP20
This unit contains fluorinated greenhouse gases covered by the Kyoto
Protocol. Maintenance and disposal operations must be only carried out by
qualified personnel in compliance with the standards in force.
WARNING
The refrigerant circuit is pressurised. Work on the appliance can be carried
out only by an authorised ATS technician or by a qualified technician.
The chiller is delivered with the necessary amount of R410A refrigerant
for its operation. It is a chlorine-free refrigerant that does not damage
the ozone layer. R410A is not flammable. However, all the maintenance
operations must only be carried out by a specialised technician with the
suitable protection equipment
Before opening the chiller, the unit must be completely disconnected from
the mains power supply.
To Next Page
Loading...
