(Numbers in the table refers to figure no.7 and figure no.6)
After stopping, turn the Main Key Switch (1.17) to OFF and remove
the key. The ON lights will turn OFF. The Electromagnetic Brake is
engaged (locked).
Note: The Electromagnetic Brake is automatically locked
whenever the Operating Lever is released and after the Breeze
stops completely.
When driving on Ramp , Steep Curbs and turns drive the Breeze C
very slowly and carefully , even consider changing the speed Limit
Potentiometer (1.11) to Lower speed mode.
When going up or down a step always drive the Breeze C so that
the wheels will get in perpendicular direction to the step and the rear
wheels wheel climb or go down together.
Never try to go on an obstacle that is more than the maximum
recommended slope angle and curb climbing . Maximum rates are in
the specification sheet.
Always drive carefully, adjust the speed according the
limitation of the road.
Before making sharp turns , reduce the Breeze C speed to
minimum to prevent side roll-over.
To climb an Obstacle drive the Breeze C forward, toward the
Obstacle. Drive until that the front wheel is touching the obstacle
and than squeeze the lever speed, keeping the direction.
Driving on
slopes and
Turns
Before making sharp turns, and especially on
slopes, reduce the Breeze C speed to minimum
to prevent side roll-over.
The Breeze C is able to go up slope higher than
the recommended safe slope. Do not drive on
slopes you are not sure about their angle.
However drive very slowly and prevent side
driving on
Now after learning through all the operating instructions, before
starting to use the Breeze C, do a visual check through the all the
parts of the vehicle, to make sure that no external damage has been
occur to the vehicle while transportation. In any case you are not
sure call your dealer and ask for an explanation.
Several parameters of the Breeze C Controller can be programmed
with a special Programmer.
Programming should be done by trained authorized technician only.
Wrong programming can cause abnormal operation of the Breeze C
,Harm persons and Injury.
It is very much recommended that when receiving as new or from
another user or after a period of not using the Breeze C a
performance check will be made as follows:
1. Switch on the main switch.
2. See that on the display panel – the battery indicator is lit and the
Ready/ON led is lit as well.
3. Squeeze the speed Wig Wag lever slowly and make sure that the
Breeze C is traveling with correspondence to the squeezing on
the lever.
4. Release the Wig Wag lever and make sure that the Breeze C is
stopping softly and that you hear a click coming from the EMB
To Next Page
Loading...
Need help?
General
