Neither transfer or reproduction of these documents nor application or disclosure
of their content are permitted without the explicit approval of AFS.
Violations will require compensation for damages.
Page 2 of 26
6.2.1
Turning the System On: ...........................................................................................................14
6.2.2
Switch off the system ...............................................................................................................14
6.3
Follow-up time .............................................................................................................................15
6.4
Motor protection: Acknowledge faults ...........................................................................................15
7
Maintenance ........................................................................................................................................16
7.1
Maintenance Work and Cycles for Oil and Emulsion Mist Separation ...........................................16
7.1.1
Metal mesh preliminary separator (pos.
•
) .............................................................................17
7.1.2
Preliminary filter fleece (pos.
‚
)..............................................................................................17
7.1.3
Longlife separator (pos.
ƒ
) .....................................................................................................18
7.1.4
Post filter H13 (Pos.
„
) ..........................................................................................................19
7.1.5
Metal mesh follow-up separator (pos.
…
) ................................................................................20
7.1.6
Ventilator (pos.
†
) ..................................................................................................................20
7.1.7
Siphon (pos.
‡
) ......................................................................................................................21
7.2
Overview of maintenance intervals...............................................................................................21
7.3
Volumetric flow rate monitoring (optional).....................................................................................23
7.3.1
MPR Functionality ....................................................................................................................23
7.3.2
MPR Connections ....................................................................................................................24
7.3.3
MPR Error Diagnostics ............................................................................................................24
8
EG-Konformitäts-Erklärung ..................................................................................................................25
9
Wear parts ...........................................................................................................................................26
Explanation of Symbols
Safety precautions, danger point, or important or absolutely mandatory instructions
Electrical connection. Caution: High voltage. Observe safety instructions. Equipment must only
be serviced by a qualified electrician (DIN EN 50 110, IEC 364).
Important additional information or advice for use
1 General Information
AFS Airfilter Systeme GmbH (AFS) manufactures highly efficient mechanical air purification devices and
systems that remove oil, emulsion, and minimal lubricant mist from the air, protecting the workplace
environment in metalworking shops.
Moreover, as a special construction, AFS also manufactures air purification devices for cleaning air
contaminated with solvents in areas that are not at risk of explosion as well as for exhaust air that accrues in
dry processing.
AFS devices are not ATEX-certified!
To Next Page
Loading...