AG Duo - Page 54

AG Duo Operation Manual
AR / 25.07.23 / Version 1 50
Problem
Possible cause
Remedy
No product being
dispensed.
Blockage.
Check for and remove
blockage.
(See Section 4.4.2)
Auger stopped due to
overload.
Reset the auger.
(See Section 4.4.1)
If the problem persists, reduce
the auger speed.
(See Section 4.3.2)
Conveyor stopped due to
overload.
Reset the conveyor.
(See Section 4.4.1)
If the problem persists, reduce
the conveyor speed.
(See Section 4.3.2)
Blockages occurring.
Auger is running too fast.
Reduce the auger speed.
(See Section 4.3.2)
Gap in the metering
shutter is too small.
Open the metering shutter to
suit the bedding in use.
(See Section 4.3.1)
Brush is lifting the mats.
Brush is set too low.
Adjust the brush height.
(See Section 4.3.3)
Brush is ineffective.
Brush is set too high
Adjust the brush height
(See Section 4.3.3)
Brush is set at the
incorrect angle.
Adjust the brush angle
(See Section 4.3.4)
Brush stopped.
Overload.
Reset the brush.
(See Section 4.4.1)
Brush lift/lower not
working.
Overload.
Reset the brush arm.
(See Section 4.4.1)
Axle not driving.
Overload.
Reset the axle.
(See Section 4.4.1)
Scraper not lifting/lowering.
Overload.
Reset the scraper.
(See Section 4.4.1)