15
SERVICING WARNING
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
5. To replace a hob element.
Lift up the ceramic hob see 4. The elements are now
accessible.
Remove the screw in the center of the element and
slide it out to the side.
Disconnect wiring from the element – make a note
of the wire colors and terminal connections. Refer to
the wiring schematic. Fit new elment and reassemble
in reverse order. Check that the wiring is correct as
shown in the wiring schematic.
6. To replace a Cooktop Warmer element.
Lift up the ceramic hob see 4. The elements are now
accessible.
Remove the screw holding the element to the
support member and slide it out to the side.
The picture shows the upper of the two Warmer
elments.
Disconnect wiring from the element – make a note
of the wire colors and terminal connections. Refer to
the wiring schematic. Fit new elment and reassemble
in reverse order. Check that the wiring is correct as
shown in the wiring schematic.
To Next Page
Loading...
Need help?
General
