Grass Seed (Bluegrass, Bentgrass)
Initial Combine Setup
RPM
r
400 0.0”-0.2” 0 - 2 **
0.75”
(19 mm)*
0.157”
(4 mm)
Fast* Solid
* - If baling straw is preferred, set chopper to low speed.
** - The Light Seed Kit #700959206 can be installed and used for grass seed
harvest but should be removed for any other crop.
Initial Header & Header Drive Setup
• Variable speed header drive in slowest position.
• Right hand pivot drive belt positioned on large countershaft d
rive
sheave.
Additional Combine Setup
• Completely block leaf screen door underneath combine with plastic or
cardboard. This will restrict incoming air to the shoe. Also block vertical
area on front side of frame x brace located in front of fan. This will restrict
incoming air to the shoe.
• May r
equire additional Separator Blanking Kit #700961967. This will block
off separator grates and level out shoe distribution.
• If separator b
lanking kit is used, use the standard reverse bar configuration
on the rotor from the factory: (3) short reverse bars and
(1) long reverse ba
r.
• If b
aling straw, move chopper speed to small sheave to slow chopper
speed down and to reduce severe chopping of straw.
• If feeder chain plugging occurs move feeder chain speed to corn speed.
• Have yo
ur dealer contact Technical Service Support for additional
adjustments required.
8
To Next Page
Loading...
Need help?
General
