Canola/Rapeseed
Initial Combine Setup
r
400-600 0.2” -0.4” 3 -5
0.75”
(19 mm)
0.375”
(10 mm)
Fast Solid
Initial Header & Header Drive Setup
• Variable speed header drive (if equipped) in slowest position for draper
headers and direct cut headers.
• Right-h
and pivot drive belt positioned on large countershaft drive sheave.
• Feed chains (front and rear) should be in high position and fast speed.
• Angle p
ickup header down so pickup attachment and pickup header auger
can breakup clumps of crop material and more evenly feed the feed chains.
Lower wind board accordingly.
Tips
• During day in dry conditions, slow the rotor down; at night when conditions
are damp speed rotor up.
• Feeder h
ouse optimization instructions for R Series, S7 and S8 Series are
available at your Gleaner dealer to increase capacity in canola.
Millet
Initial Combine Setup
r
525 0.2” -0.3” 2 - 4
0.625”
(16mm)
0.1875”
(5mm)
Fast Solid
• Blanks may be r
equired.
5
To Next Page
Loading...
Need help?
General
