Product: Primary
Tillage
Model: SS7400
Bulletin: 2PD684599
Date: May 1999
SS7400 SOIL SAVER
®
- Basic Setup
ASSEMBLY SAFETY
CAUTION! TO AVOID PERSONAL INJURY,
READ, UNDERSTAND AND FOLLOW
THE SAFETY INFORMATION BELOW.
•
The person or persons who assemble this
machine must have the ability to read,
understand and follow the step by step
assembly procedures and safety instruction
outlined herein.
•
Wear personal protective equipment (PPE)
such as, but not limited to, protection for
eyes, lungs, ears, head, hands and feet
when operating, servicing or repairing
equipment.
•
Use lift crane, jack, tackle or fork lift truck to
lift heavy parts and assemblies.
•
Keep clear of parts which may move or
drop when removing shipping straps or
brackets.
•
Assembly area should be level, clean and
free of debris to prevent assembly
personnel from tripping or failing.
•
Inspect all parts for sharp edges, grease, oil
or dirt which might cause injury during
assembly.
•
If machine requires blocking up, use
blocking material of adequate strength and
in good condition. Blocks must be on a
smooth dry surface.
•
Never place any part of your body under
blocked-up assemblies if at all possible.
•
If welding or flame-cutting is required, be
sure no flammable materials are in the
area. Also, clear bystanders from area.
•
After completing each assembly step,
review next step in procedure before
proceeding with that step.
•
Neatly arrange parts and tools within easy
reach of work area.
•
Openings in the skin and minor cuts are
susceptible to infection from hydraulic fluid.
If injured by escaping fluid, see a doctor at
once. Without immediate medical
treatment, serious infection can occur.
•
Never use your hands to locate a hydraulic
leak. Use a piece of wood or cardboard.
Hydraulic fluid escaping under pressure can
penetrate the skin.
•
Correct fluid leaks before using equipment.
BEFORE DELIVERY
•
After completing assembly of machine, be
sure all nuts, bolts, other fasteners, and
hydraulic fittings are properly tightened.
•
Be sure all safety guards and safety locking
devices are in place.
•
Be sure machine is completely lubricated.
•
Before operating the machine, be sure to
read the OPERATION section of operator’s
manual.
•
Before delivering the machine, review
machine maintenance, operation, and
safety with the customer.
•
Complete the Predelivery Inspection and
Service Report at the end of these
instructions.
1
To Next Page
Need help?
General
