ASSEMBLY SAFETY -------------------------------------1
PRELIMINARY INSTRUCTIONS -------------------------------2
7 & 9-SHANK MODELS, RIGID FRAME, SINGLE-AXLE--------------------4
7, 9, 11, 13-SHANK MODELS, RIGID FRAME, WALKING BEAM AXLE ------------6
15 & 17-SHANK MODELS, FOLDING MAIN FRAME ---------------------8
15 & 17-SHANK MODELS, FOLDING WING FRAME --------------------10
MAIN FRAME SLICER, ALL MODELS ----------------------------11
WING FRAME SLICER, FOLDING MODELS ------------------------12
HYDRAULIC SYSTEM, RIGID MODELS---------------------------13
HYDRAULIC SYSTEM, FOLDING MODELS -------------------------14
HYDRAULIC SYSTEM CHARGING -----------------------------17
SHANK HOLDERS -------------------------------------19
DEEP-TILL SHANKS ------------------------------------20
SHANK LOCATIONS ------------------------------------21
FIVE-BAR SPIKE TOOTH HARROW ----------------------------24
HARROW LOCATION ------------------------------------26
RIGID LEVELER --------------------------------------32
LEVELER LOCATION ------------------------------------33
HYDRAULIC SLICER LIFT ---------------------------------39
TRANSPORT LIGHTS AND REFLECTORS -------------------------41
LIGHT LOCATIONS -------------------------------------43
TRANSPORT LIGHT WIRING DIAGRAM --------------------------49
TORQUE VALUES -------------------------------------50
PREDELIVERY SERVICE AND INSPECTION REPORT
3
TABLE OF CONTENTS
To Next Page
Loading...
