What to do if AGFA CR 30-X Medical Equipment shows empty cassette error or image plate jam?
If you receive an error indicating an empty cassette or an image plate jam, switch off the digitizer and open the front cover. Check if there is no image plate visible in the transport unit, then close the cover and switch the digitizer back on. After the restart, remove the cassette from the digitizer and check if there is an image plate inside.
What to do if AGFA CR 30-X shows error during writing on RF-tag?
If you receive an error during writing on the RF-tag after scanning, confirm the message by pressing the OK button on the PC. Then, remove the cassette, push the erase button on the digitizer, and re-enter the cassette for a manual erase cycle.
What to do if AGFA CR 30-X Medical Equipment shows error during read-out of the ID data?
If you encounter an error during the read-out of the ID data, confirm the message by clicking the OK button and then re-identify the cassette.
What to do if AGFA Medical Equipment CR 30-X does not start?
If your AGFA Medical Equipment CR 30-X does not start, first check the power supply. If the power supply is working, contact your local service engineer for assistance.
What to do if AGFA CR 30-X shows communication error due to Ethernet cable?
If you receive a communication error and suspect the Ethernet cable, first, verify that the Ethernet cable is securely plugged into both the PC and the digitizer. Next, visually inspect the cable for any signs of damage. If the problem persists after checking the cable, try restarting both the PC and the digitizer. If the issue still continues, contact service.
How to fix connection problem between AGFA digitizer and NX PC?
To resolve a connection issue between the digitizer and the NX PC, begin by checking the Ethernet cables to ensure they are properly connected. If the problem persists, restart both the PC and the digitizer. If the error continues after restarting, contact service.
How to troubleshoot AGFA CR 30-X Medical Equipment digitizer that does not start?
If the digitizer fails to start, check the power supply to ensure it is functioning correctly. If the power supply is working, contact your local service engineer for further assistance.
What to do if the erasure lamp failed during scanning cycle on AGFA digitizer?
If the erasure lamp fails during a scanning cycle, try restarting the digitizer. If the problem continues after restarting, contact service.
What to do if there is a connection problem between AGFA digitizer and the Digitizer Remote Display?
If you encounter a connection problem between the digitizer and the Digitizer Remote Display, check if the Digitizer Remote Display is running. Try starting or restarting the Digitizer Remote Display.
Why AGFA CR 30-X Medical Equipment digitizer cannot detect the cassette chip?
If the digitizer cannot detect the cassette chip, open the cassette and check if the tray is inserted correctly. Alternatively, try using another cassette. If the issue persists, contact service.
General| Grayscale Resolution | 16 bits |
|---|---|
| Connectivity | DICOM 3.0 |
| Type | Computed Radiography (CR) |
| Resolution | 10 pixels/mm |
| Power Supply | 50/60 Hz |
| Plate Sizes | 35 x 43 cm |
| Pixel Size | 100 µm |
To Next Page
