Cleaning
To clean the exterior of the equipment:
1. Stop the system
WARNING:
When the equipment is going to be cleaned, be sure to turn
OFF the power of each device, and to unplug the power cord
from the AC outlet. Otherwise, it may result in fire or electric
shock.
2. Wipe the exterior of the system with a cloth slightly moistened with a
neutral detergent. Some approved disinfectants can be used for cleaning
as well.
CAUTION:
Make sure no liquid gets in the device.
CAUTION:
Clean the equipment with only a little moisture. Do not
spray disinfectants or detergents directly on the equipment.
Do not pour liquid directly on the equipment.
CAUTION:
Liquids ingressing the DR Detector may cause malfunction
and contamination. Take special care near the cable
connector on the side of the DR Detector.
CAUTION:
Do not use abrasive brush and scraper to clean the product.
Note: Do not open the equipment for cleaning. No
components inside the device require cleaning by the user.
3. Start up the system.
Related Links
Approved disinfectants on page 37
34 | DR 18M, DR 24M | Introduction to the DR Detector
0380A EN 20180703 1429
To Next Page
Loading...
