Agilent Technologies 16900 Series Service Guide

118
Chapter 6: Replacing Assemblies
b Tighten the cable clamp screws (H5) to 5 in/lb.
CAUTION: If you over tighten the screws, the threaded inserts on the rear panel, the threaded
inserts on the circuit board, or the cable clamp itself might break. Tighten the screws only
enough to hold the cable in place, approximately 5 in/lb.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Agilent Technologies 16900 Series Specifications

General

Brand	Agilent Technologies
Model	16900 Series
Category	Measuring Instruments
Language	English