Agilent Technologies 53220A - Page 277

53220A/53230A User’s Guide 277
53220A/53230A Error Messages A
-123 Exponent too large
The magnitude of the exponent is greater than
32,000.
-124 Too many digits
The mantissa (the positive fractional part of the
number) contains more than 255 digits.
-128 Numeric data not allowed
A number was specified in the command header
or in a parameter where numeric data is not
allowed.
-130 Suffix error
An error was detected in the suffix (units) of a
numeric parameter, but more specific information
is not available.
-131
Invalid suffix
The parameter suffix is specified incorrectly
(e.g. 10 MZ rather than 10 MHZ).
-134
Suffix too long
A suffix contains more than 12 characters.
-138
Suffix not allowed
A suffix was specified for a numeric parameter
when one is not allowed.
-140
Character data error
A character error was detected in the command
header or in a parameter, but more specific infor-
mation is not available.
-141
Invalid character data
Either an invalid character was received, or the
character is not valid for the command header.
-144
Character data too long
The character data contains more than 12 charac-
ters.
-148
Character data not allowed
A valid character was specified when another
data type (numeric, boolean) is required.
-150
String data error
An error was encountered in the string specified,
but more specific information is not available.
-151
Invalid string data
A required string parameter was received but is
invalid.
-158 String data not allowed
A valid string was specified when another data
type (numeric, boolean) is required.
-160 Block data error
An error was encountered in the block data, but
more specific information is not available.
-161 Invalid block data
The number of bytes in a definite length data
block does not match the number of bytes indi-
cated by the block header.