Agilent Technologies 53220A - Rise Time and Fall Time

94 53220A/53230A User’s Guide
3 53220A/53230A Measurements
Rise Time and Fall Time
An example of rise and fall times on an input signal are shown in Figure 3-8.
Figure 3-8. Rise Time and Fall Time Measurements.
The commands used to make rise and fall time measurements are:
MEASure:RTIMe? [{<lower_ref>|MINimum|MAXimum|DEFault}
[,{<upper_ref>|MINimum|MAXimum|DEFault}]] [,<channel>]
CONFigure:RTIMe [{<lower_ref>|MINimum|MAXimum|DEFault}
[,{<upper_ref>|MINimum|MAXimum| DEFault}]] [,<channel>]
+ width
-width
frequency
t
r
t
f
1
0
9
0