Step 11: Download Device Drivers
If your instrument is not listed in the table below, you must download the device driver so that the
mainframe can interpret the instrument’s SCPI (Standard Commands for Programmable Instruments)
commands. Device drivers enable register-based modules to be programmed using SCPI commands.
Factory Installed Device Drivers:
Register-Based Device
Model Number
Device Description
Agilent E1326B 5 1/2-Digit Multimeter
Agilent E1328A 4-Channel D/A Converter
Agilent E1330B Quad 8-Bit Digital Input/Output
Agilent E1332A 4-Channel Counter/Totalizer
Agilent E1333A 3-Channel Universal Counter
Most Switch Modules Multiplexers, Matrix, General Purpose
Drivers that are not factory-installed are on a disk shipped with the module. Instructions for downloading the
drivers are included in the Downloading Device Drivers Installation Note. If a driver is not installed, the
mainframe will report the following message to the display (Agilent E1301B) or to an external terminal at
the end of the power-on sequence.
WARNING: DEVICE DRIVER NOT FOUND
1-20 Installing the System
To Next Page
Loading...