Agilent Technologies 8163A - Page 164

Measurement Operations & Settings Signal Conditioning
164 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition
command:
:CONFigure[n][:CHANnel[m]]:OFFSet:WAVelength:TABle?
syntax: :CONFigure[n]][:CHANnel[m]]:OFFSet:WAVelength:TABle?
description: Queries the complete the offset table.
parameters: none
response: SCPI binary block format format (Intel byte order); wavelength:offset pairs in ascending
order.
Each value pair is transferred as 12 bytes; 8 bytes represent the wavelength, 4 bytes rep-
resent the offset.
example: CONF1:OFFS:WAV:TAB? → binary block interpreted as, for example:
1.55e-6 | 12 | 1.7e-6 |3.4 |.....
affects: All attenuator modules.
command:
:CONFigure[n][:CHANnel[m]]:OFFSet:WAVelength:TABle:SIZE?
syntax: :CONFigure[n]][:CHANnel[m]]:OFFSet:WAVelength:TABle:SIZE?<wsp>MAX | MIN
description: Without optional parameter, queries the size of the offset table.
parameters: MAX
MIN
Queries the maximum size of the offset table.
(available flash memory
→ 1000 entries)
Queries the minimum size of the offset table. (should
→ 0)
response: 4 byte unsigned integer; offset table size.
example: CONF1:OFFS:WAV:TAB:SIZE? → 50
affects: All attenuator modules.