4-3
Supplement for the User’s Guide (Firmware Version 7.68)
Using This Chapter
— Add two new sections (“Calibrating Using Electronic Calibration (ECal)” starting on
page 4-17 and “Adapter Removal Using ECal (ES Analyzers Only)” starting on
page 4-29) to the end of the chapter.
• Operating Concepts Chapter
— Append the Enhanced Reflection Calibration information to the end of the
subsection titled “Enhanced Response Calibration” (part of the “Calibration
Routines” section). See page 4-37.
— Append the subsection titled “ECal” to the end of the section titled “Calibration
Routines.” See page 4-37.
• Safety and Regulatory Information Chapter
— Replace the warning describing the line fuse type and rating with a revised warning
in the “Servicing” subsection of “Safety Considerations.” See page 4-39.
To Next Page
Loading...
