Agilent Technologies 8753ES

4-4
Supplement for the User’s Guide (Firmware Version 7.68)
Conversion Loss Using the Frequency Offset Mode
Conversion Loss Using the Frequency Offset Mode
Performing a Power Meter (Source) Calibration Over the IF Range
In Step 2 of this section, change the softkey to
.
High Dynamic Range Swept RF/IF Conversion Loss
Perform a Power Meter Calibration Over the IF Range
In Step 4 of this section, change the softkey to
.
Fixed IF Mixer Measurements
Sequence 1 Setup
Performing a Response Calibration
Change the softkey to in two
places in this section.
Addressing and Configuring the Two Sources
Change the softkey to in three
places in this section.
Sequence 2 Setup
Incrementing the Source Frequencies
Change the softkey to in two
places in this section.
ADDRESS: P MTR/HPIB
ADDRESS: P MTR/GPIB
ADDRESS: P MTR/HPIB
ADDRESS: P MTR/GPIB
PERIPHERAL HPIB ADDR
HIB ADDR
PERIPHERAL GPIB ADDR
HIB ADDR
PERIPHERAL HPIB ADDR
HIB ADDR
PERIPHERAL GPIB ADDR
HIB ADDR
PERIPHERAL HPIB ADDR
HIB ADDR
PERIPHERAL GPIB ADDR
HIB ADDR