Chapter 3 Front-Panel Operation
Remote Interface Configuration
60
5
Save the change and turn off the I/O configuration mode.
The RS-232 baud rate and parity selections are stored in non-volatile memory,
and does not change when power has been off or after a remote interface reset.
The power supply displays a message to show that the change is now in effect.
If the baud rate and the parity are not changed, “NO CHANGE” will be displayed
for one second.
Note
To exit the I/O configuration mode without any further changes, press the
“I/O Config” key until the “NO CHANGE” message is displayed.
CHANGE SAVED
I/O Config
To Next Page
Loading...
Need help?
General
