Installation Note E4440-90611 11
Installation Procedure
14.Attach the W66 cable to the SMB connector on the A31 Wideband Analog IF
assembly. This is the cable you left unattached in step 10.
15.Locate the cable with the “95” color code in the kit. Connect the SMB end of the cable
to the A11 Reference assembly's 300 MHZ Out connector. Route the cable towards the
fans and then between the A7 Digital IF assembly and the A31 Wideband Analog IF
assembly. Connect the other end of the cable to the A31 Wideband Analog IF at the
jack marked “95”.
16.Locate the cable with the “65”color code in the kit. Connect the SMB end of the cable
to the A11 Reference assembly's 100 MHZ Out connector. Route the cable towards the
fans and then between the A7 Digital IF assembly and the A31 Wideband Analog IF
assembly. Connect the other end of the cable to the A31 Wideband Analog IF at the
jack marked “65”.
17.Locate the ribbon cable in the kit. Notice that the cable is marked for proper
orientation to assure the WB AIF end and the WB DIF end is connected to the correct
wideband IF assembly. Install the cable by sliding the middle of the cable under the
board extractor on the A32 wideband Digital IF assembly. Connect the cable to one of
the wideband IF assemblies then push the cable down between the two assemblies.
Connect the other end of the cable. Assure the connectors are well seated and check
that the board extractor lays flat and does not pinch the cable.
To Next Page
Loading...
Need help?
General
