64 Chapter 2
Basic Operation
Using Data Storage Functions
This saves this instrument state in sequence 1, register 01 of the instrument state register.
5. Press
Add Comment to Seq[1] Reg[01].
This enables you to add a descriptive comment to sequence 1 register 01.
6. Using the alphanumeric softkeys or the knob, enter a comment and press
Enter.
7. Press
Edit Comment In Seq[1] Reg[01].
If you wish, you can now change the descriptive comment for sequence 1 register 01.
After making changes to an instrument state, you can save it back to a specific register by
highlighting that register and pressing Re–SAVE Seq[n] Reg[nn].
Recalling an Instrument State
Using this procedure, you will learn how to recall instrument settings saved to an instrument state
register.
1. Press
Preset.
2. Press the
Recall hardkey.
Notice that the
Select Seq softkey shows sequence 1. (This is the last sequence that you used.)
3. Press
RECALL Reg.
The register to be recalled in sequence 1 becomes the active function. Press the up arrow key
once to select register 1. Your stored instrument state settings should have been recalled.
Deleting Registers and Sequences
These procedures describe how to delete registers and sequences saved to an instrument state
register.
Deleting a Specific Register within a Sequence
1. Press
Preset.
2. Press the
Recall or Save hardkey.
Notice that the
Select Seq softkey shows the last sequence that you used.
3. Press
Select Seq and enter the sequence number containing the register you want to delete.
4. Press
Select Reg and enter the register number you want to delete.
Notice that the
Delete Seq[n] Reg[nn] should be loaded with the sequence and register you want to
delete.
5. Press
Delete Seq[n] Reg[nn].
This deletes the chosen register.
Deleting All Registers within a Sequence
1. Press Preset.
2. Press the
Recall or Save hardkey.
Notice that the
Select Seq softkey shows the last sequence that you used.
To Next Page
Loading...
Need help?
General
