Installation Note E8362-90004 29
Step 16. Enter the New Model Number
Procedure Requirements
• The analyzer must be powered up and operating to perform this procedure.
• The Network Analyzer program must be running.
• A keyboard and mouse are required for this procedure.
Enter the New Model Number
1. On the analyzer’s System menu, point to Service, then click Option Enable.
2. Click Repair.
3. Check Model shown is incorrect!, then click Begin Repair.
4. In the Model Change box, select the new model number, E8363B.
5. Using the keyboard, enter the keyword in the box provided. The keyword is printed on the
License Key Certificate. Enter this keyword exactly as it is printed on the certificate.
6. Click Enter Model.
7. Verify that the new model number displayed is correct, then click YES. If it is not correct,
click NO and repeat the repair.
8. When the installation is complete, click Exit.
Verify that the New Model Number is Shown Correctly
1. On the analyzer’s Help menu, click About Network Analyzer.
2. Verify that the new model number, E8363B, is shown correctly in the display. Click OK.
3. On the analyzer front panel, press Preset. Verify that the full frequency range of the
analyzer is correct. The analyzer should preset to a frequency range of 10 MHz to 40 GHz.
NOTE
If the model number is not shown correctly, perform “Enter the New Model
Number” again. If the option is still not enabled or the analyzer does not preset
to the correct frequency range, contact Agilent Technologies. Refer to “Getting
Assistance from Agilent” on page 3.
To Next Page
Loading...
Need help?
General
