Agilent Technologies N9310A Quick Start Guide

12 Quick Start Guide
N9310A RF Signal Generator
Enable RF Sweep
Operation Notes
1. Press hardkey
Turn on the RF OUT connector. Notice
that the display annunciator changes
from to .
2. Press Return>Sweep Mode Displays another menu allowing you to
choose the sweep mode
3. Press RF softkey The indicates sweep on,
signifying that the sweep mode is
enabled. The sweep signal is now
available at the RF OUT connector.
RF
On/Off

Agilent Technologies N9310A Specifications

General

Brand	Agilent Technologies
Model	N9310A
Category	Test Equipment
Language	English