Why is there no beeper tone on my Agilent Technologies U1241A?
If you are not hearing a beeper tone from your Agilent Technologies Multimeter, verify in the setup mode if the beeper is set to OFF. If it is, select the desired driving frequency.
How to fix no LCD display on Agilent Technologies Multimeter after power ON?
If there is no LCD display after you power on your Agilent Technologies Multimeter, check the battery polarity and replace the batteries if needed. When replacing, use new batteries and avoid mixing old and new ones.
General| Display Type | LCD |
|---|---|
| Digits | 4 |
| Continuity | Yes |
| Diode Test | Yes |
| Data Hold | Yes |
| Backlight | Yes |
| Safety Category | CAT III 1000 V, CAT IV 600 V |
| Operating Temperature | 0 °C to 50 °C |
| Storage Temperature | -20 °C to 60 °C |
| Weight | 400 g |
| Basic AC Current Accuracy | 1.0 % + 3 digits |
| Battery Life | 200 hours |
| Power Source | Battery |
To Next Page
