AGM Global Vision16
2.3 CLIENT SOFTWARE INTRODUCTION
We recommend using T-Vision (V5.4.12 and below) software. Install the client
software on your mobile phone first, and then connect your phone to the hotspot
of the monocular. Refer to chapter 2.2.11 for details of hotspot connection.
NOTE:
The device password is set by user at first activation. If the password was lost
or forgotten, it can be reset. To make a reset, provide the following action:
1. When the monocular is turned on, hold the button
for three seconds to
activate the OSD menu.
2. Move the cursor to
menu item and press the button to restore all
parameters to default settings.
1. Open the APP and connect the phone or pad with the device.
Asp-Micro TM160
To Next Page
Loading...
