Operation
3. Once you have made your changes, they will be saved and will be
used every time the tester is turned on.
4. If you are done making changes to the offset, without pressing any
buttons, wait approximately 10 seconds and the tester will return to
“NORMAL OPERATION MODE”. If you want to make changes to
another mode you can press the mode button again to change to the
next mode of operation.
5. Once you have made your changes to the offset and if you have a
offset applied, when the tester returns to “NORMAL OPERATION
MODE” the triangular indicator (F) will be solid and pointing to “OFF-
SET”. This indicates that you have an offset applied in the tester.
SETTING THE HIGH LIMIT
By default the high limit is turned off. The high limit can be set within a
range of 9 to 30% in 1% increments.
1. Press the mode button (B) until the triangular indicator (F) is blinking
next to “HIGH LIMIT”.
2. Use the arrow buttons (C) to adjust the high limit up or down.
NOTE: If there is no high limit applied, or you wish to turn the
high limit off, simply use the arrow buttons (C) until the word
“OFF” is displayed for the high limit.
3. Once you have made your changes they will be saved and will be
used every time the tester is turned on.
4. If you are done making changes to the high limit, without pressing
any buttons, wait approximately 10 seconds and the tester will return
to “NORMAL OPERATION MODE”. If you want to make changes to
another mode you can press the mode button to change to the next
mode of operation.
5. Once you have made your changes to the high limit, and if you have a
high limit applied, when the tester returns to “NORMAL OPERATION
MODE” the triangular indicator (F) will be solid and pointing to the “HIGH
LIMIT”. This indicates that you have a high limit applied to the tester.
NOTE: The tester will beep if you have a high limit set and the hay
moisture is above the set limit.
18
To Next Page
Loading...
