Power Hoe 900 / 900-S 27
4. Commissioning and Operation
4
Type 0900-S
Start the engine
l
Pull the clutch hand lever (A/24)
slightly and unlock pawl (A/25).Then
release the clutch hand lever and, at the
same time, increase the engine speed
using the speed control lever . The hoe-
ing tools start rotating.
To adjust the desired working depth, set
the depth bar to one of the two depth
settings.
Danger zone
W
Keep out of the machine’s
danger zone during starting
and operation.
l
Only move the power hoe on concrete
and asphalted ground with the engine
shutt off and the front support wheel
mounted.
W
Warning: Do not clean the
hoeing tools while the engine
is running. Shut off the engine and re-
move the spark plug connector. Remove
jammed objects only by means of tools,
e.g. a wooden stick.
To clean and exchange the hoeing tools,
only recline the machine backwards
onto the handlebar (before, remove the
depth bar).
Danger
zone
25
24
To Next Page
Loading...
