6 Power Hoe 900 / 900-S
Fitting the Steering Handle Type 0900 021/121
Open the box top
Mount handlebar
l
Fit the steering handle (1)
into the appropriate receptacle
(4) and attach it using clamp
(3) and attachment bolts (5 +
6).
l
Insert eccentric lever (2) into
the bottom hole of the clamps
and tighten it using washer (7)
and nut (6) so that it still allows
swivelling the handlebar up
and down when it is unlocked.
l
If the eccentric lever does
not lock the handlebar tight
enough, tighten the nut (8).
Attach the gas control lever
(9) to the end of the right han-
dlebar using the attachment kit
(10–12).
Connect the electric line for
safety circuit lever to the socket
(13 +14).
l
Inspect again whether ca-
bles are routed properly and
are not twisted or jammed to
avoid clutch problems.
Adjust the handlebar to the
desired height and lock with
eccentric lever (2).
Mount hoeing tools and
hoeing guards.
Mount depth bar
Mount front support wheel
Carry out all steps for start-
ing-up
20
21
22
22 23
To Next Page
Loading...
