Agria 900 - General; Cleaning

Power Hoe 900 / 900-S 33
5. Maintenance: General, Cleaning
5
Adjustments on
Hand Levers (Type 900-S)
Check clutch play or clutch adjustment
each time you operate the machine. If
necessary, re-adjust (especially after
commissioning the machine during
break-in period, and after exchanging
clutch linings and brake pads).
Clutch
X = 3–5 mm (clutch play)
! = The bowden cable must be placed in
the hand lever support on top position!
General
Watch out for fuel
and oil leakage and
repair, if necessary.
Regularly check
bolts and nuts for
tight fit and retighten,
if necessary.
Once a year and
after cleaning slightly
grease all gliding and
moving parts (e.g.
speed control lever,
hand lever bearing,
etc.) with Bio-lubricating grease and Bio-
slushing oil.
66
66
6 A
 Remove retaining spring (2) and use
set pin (4) to press cable end (3) out of
bracket in hand lever.
 Adjust the set pin (4) to a play of X
 Hook the cable end into the bracket
with the set pin and fit retaining spring
(2).
Cleaning
Engine
Clean the engine only with a cloth. Avoid
spraying with a pressure washer, as
water might leak into ignition and fuel
system, causing malfunctions.
Machine
After each operation immediately clean
the tilling tools. Grease all gliding parts
with Bio-lubricating grease and Bio-
slushing oil.
After each cleaning with a pressure
washer lubricate all lubrication points
and let power hoe run for a short time to
press water out.
Apply grease generously to leave a grease
ring around bearings to prevent water, plant
sap, and dirt from penetrating.


