pg 22
Safety Edge Installation
m Attach the radio receiver
inside of the gate operator in a place
where the antenna may be extended
out of the operator enclosure. This
may lead to many possible locations
so a suggestion would be to place the
receiver beside the receiver that
already exists (if equipped). If the gate
operator is not equipped with a
receiver, place the new receiver where
the factory equipped receiver would
normally go (See parts identification).
m Attach the four wires from
the receiver to the control board as
indicated by the illustration to the left.
Connect either one of the grey wires to
terminal 4, the other grey wire to
terminal 6, the black wire to terminal 8,
and the red wire to terminal 12.
m The switch settings inside
of both the transmitter and receiver
always come from the factory with the
same setting and it is therefor advis-
able to change this setting to insure
that is cannot be duplicated. This can
be done by first setting the switches in
the receiver to any arbitrary setting
and then setting the switches inside of
the transmitter to match exactly those
switches that are in the receiver. A
paper clip may be used to flip the
switches.
m Test the safety edge by
activating the gate operator so that the
gate is heading in the closing direction.
While the gate is traveling closed,
stand beside the gate (not directly in
front of the gate) and press firmly on
the safety edge to see if the gate will
reverse. Repeat this several times with
the gate in different positions of the
closing travel.
m Test the safety edge at
least once a month and replace the
batteries in the transmitter if neces-
sary.
To Next Page
Loading...
