TR10K001-A RE / 04.2009
11
ATTENTION
Damage to the electronics caused by external voltage
External voltage on the connecting terminals of the control
will destroy the electronics.
Do not apply any mains voltage (230/240 V AC) to the
connecting terminals on the control.
Observe the following during fitting:
The garage ceiling must guarantee secure fastening of the •
operator. For ceilings which are too high or too light, the
operator must be fastened on additional struts.
Emergency release lock3.2.1
An emergency release lock (see Accessories for garage door
operator D7, to be ordered separately) is required for garages
without a second entrance in order to prevent users from
locking themselves out in the case of a power failure.
Check the function of the emergency release lock every
month.
Attaching a warning sign3.2.2
Attach the sign warning about getting trapped in a
noticeable place or near the permanently installed
operator buttons.
ENGLISH
To Next Page
Loading...